16.810: Engineering Design and Rapid Prototyping
(IAP 2004 course number: 16.682)
SolidWorks, CosmosWorks, Omax, and Water Jet Manual
Version 1.0 12/16/2003
Bill Nadir bnadir@mit.edu
Purpose
The purpose of this document is to provide a rough procedure of how to perform many of the tasks required of students in 16.810 (temporary class number 16.682 in IAP 2004). Basic procedures of how to model a part in SolidWorks, perform structural analysis using CosmosWorks, and how to use the computer-aided manufacturing (CAM) tools for manufacturing with a water jet cutter are detailed in this document. This document is not meant to be complete and questions should be referred to the instructors or to another reference document. A flow chart of the various tasks covered in this document is shown below in Figure 1.
Figure 1 Flow chart
Table of Contents
PURPOSE ..................................................................................................................................................... 2 TABLE OF CONTENTS ............................................................................................................................. 2 TABLE OF FIGURES ................................................................................................................................. 3 PROCEDURE FOR CREATING SOLIDWORKS CAD MODEL OF A 2-D PART ............................. 4 PROCEDURE FOR COSMOSWORKS STRUCTURAL ANALYSIS OF CAD MODEL OF A 2-D PART ............................................................................................................................................................. 6 PROCEDURE FOR CREATING SOLIDWORKS DRAWING OF A 2-D PART................................ 20 PROCEDURE FOR CREATING OMAX LAYOUT OF A 2-D PART ................................................. 21
2
Table of Figures

下一页